1. The power cable & security stand will connected, and cable line can be go throgh the side groove or bottom.
2. Tear off the bottom sticker, then install it tightly on the clean table(Press time within 10 seconds).
3. Insert the touch sensor cable into the back interface.
4. Tear off the sticker with touch sensor.
5. Paste on the phone back with touch sensor,then it will connected the power adator with security stand.
6. Connect the charging cable with mobile phone, it is successful to install the security stand when you hear a alarm sound.
1. Security system is used to secure consumer electronic gadgets in exhibition or store open display against theft. This innovative system is easy to operate and is able to blend easily in any exhibits layout.
2. Charging function: The stand alone security device built in lithium battery, if the power outages that is also with security function. One set of external 5V power adapter, and it can be supply products for charging.
3. Alarming function:
– Contactor alarm: When we pull up the contactor and back of parts VBH adhesive, then it will immediately issued warming sound.
– Cutting cable alarm: When the alarm cable was pulled apart or cut off, then it will immediately issued warming sound.
4. Remote control function: The infrared remote control, anti-interference ability, sensitivity strong.
5. Material: ABS
6. Alarm volume: 95-120dB
7. Input voltage: 110-240V
8. Charging voltage: DC 5V 1A
9. Unlock: Infrared remote control
10. Size: 7.5x5x5cm